Never Use of Kill -9 form letter

It doesn't give the process a chance to cleanly:

1) shut down socket connections

2) clean up temp files

3) inform its children that it is going away

4) reset its terminal characteristics

and so on and so on and so on.

Generally, send 15, and wait a second or two, and if that doesn't
work, send 2, and if that doesn't work, send 1.  If that doesn't,
REMOVE THE BINARY because the program is badly behaved!**

Don't use kill -9.  Don't bring out the combine harvester just to tidy
up the flower pot.

But what do the numbers mean? Well, they are increasingly violent ways to ask the program to stop itself. The command kill -9 isn’t asking the program to stop, it’s asking the O/S to stop running the program now, regardless of what it’s doing.

Run order of kills:

kill -15 : this is the equivalent of kill -sigterm and it the default. The program should terminate after it has finished what it is doing.

kill -2 : this is the equivalent of kill -sigint and is the same as pressing CTRL+C. This should mean “stop what you’re doing” — and it may or may not kill the program.

kill -1 : this is the equivalent of kill -sighup and tells the program that the user has disconnected. (e.g. SSH session or terminal window was closed). It usually results in a graceful shutdown of the program.

The executing program needs to be coded to recognise these kill signals, and all good software will spot them.

The other fun kill command is kill -sigstop. This can’t be blocked (like -9) as it’s an O/S level command too, but freezes the program execution like pressing CTRL+Z. You can continue the program execution later using kill -